New-build BMS delivery
End-to-end controls delivery from design review through to commissioned handover.
Where BMS packages fail during design and delivery
Most controls problems are designed in, not built in. Incomplete points schedules, unresolved integration boundaries and network architecture left to procurement create cost, programme risk and a system that cannot be commissioned cleanly.
Servomatrix scope, from design review to handover
We review the design intent, set the architecture and integration boundaries, engineer panels, write and audit the programming, build operator graphics, support installation, and run point-to-point and functional testing through to witnessed handover.
Required inputs
- Mechanical equipment schedules
- Consultant specifications
- HVAC schematics
- Available layouts and electrical interfaces
- Integration responsibilities matrix where available
Typical deliverables
- BMS architecture and topology diagram
- Points schedule and I/O budget
- DDC panel schematics
- Sequences of operation
- Commissioning records
- As-built and handover pack
Procurement and coordination considerations
Integration scope depends on available manufacturer interfaces, approved gateways, protocol documentation and project responsibilities. We define these boundaries early so they are priced and coordinated rather than discovered on site.
One documented architecture, field device to operator interface.
DDC control. Direct digital controllers running the sequences, local to plant and field.
- 01
Field devices
Sensors, actuators, valves, drives and metering at the plant and zones.
- 02
DDC control
Direct digital controllers running the sequences, local to plant and field.
- 03
Integration network
BACnet and Modbus over IP and serial, plus gateways to third-party systems.
- 04
Supervisor / operator layer
Graphics, alarms, trends, schedules and reporting for daily operation.
- 05
Remote support and analytics
Secure remote visibility, alarm review and trend analysis after handover.
Discuss this scope on your project
Send the available drawings, specifications, points schedule or project brief. We will review the control requirements and identify the most practical next step.